展开Lumia Penetrado red LED light heating beauty device is a result of years of research, development, and clinical trials, in order to achieve the best results of noninvasive anti-aging beauty treatment. The Penetrado device consists with 26 pcs 625 nm red lights and 8 pcs 850nm far-infrared light that penetrates all 3 layers of the skin. The LED light causes subdermal micro burns, that once healed, cause your body to produce new collagen and elastin fibers. With that, contributing to reduction of wrinkle, pigmentation, and other visual skin conditions. Lumia Penetrado uses a surface made of a high tempered glass sensor of a perfectly equal density. This innovative glass sensor probe surface contributes to even scattering of the light and heat energy, that can transfer 50.5 ±3° C . Reflecting an even treatment energy for your entire face. Using the Lumia Penetrado to apply cosmetics (cream, serum) during the treatment, is a more efficient method to enhance penetration of the active and beneficial ingredients in to your skin. Application - Step 1 - Wash and dry your face. The skin should be clean, dry and free of any powder, gel or cream. Step 2 - Lift the applicator from its cradle in the base unit. Press the On/Off switch. The device will beep once and the Indicator Light will lit one after another for a short time and then the Green indicator will turn steady on. Your machine is ready for the treatment. Step 3 - Place the TREATMENT PROBE on the area that you want to treat first. The LED light will automatically activate. Apply light pressure while slowly moving the APPLICATOR in small circular motions. The Treatment probe surface treatment will slowly increase. Remove the Applicator from the skin if either the skin or the Applicator is too hot. Perform the treatment for 5-7 minutes on each treatment area. Important - Keep the device in constant motion when in contact with the skin! Holding the device still while treating can cause redness or a mild burn. Step 4 - When you are done with your treatment, turn OFF the Applicator by pressing the ON/OFF SWITCH. The device will beep once and the WORKING INDICATOR LIGHT on the Applicator will turn off. Step 5 - Always apply a small amount of a moisturizing cream on the treated skin areas after each session and massage it gently in circular motions. Step 6 - It is imperative to clean the glass probe after each use. Unplug the device from its charging base to clean it. Clean the probe thoroughly by using dry cloth, cotton ball or paper towel. Refrain from using sanitizing substances to avoid paint damage. Oly the device's glass probe is suitable for direct contact with creams and/or serums. Note - A mild redness - After each use you may notice a slight reddening of the skin (mild erythema) of the treated area. This is normal and should fade within 24-48 hours. Discontinue use if you encounter any discomfort or skin redness that lasts for longer than 48 hours.